# connect encoder count, select the one you need
net jog-counts       pendant.jog-wheel-counts
net jog-counts       axis.x.jog-counts 
net jog-counts       axis.y.jog-counts 
net jog-counts       axis.z.jog-counts
 
net jog-x   axis.x.jog-enable   <=   pendant.jog-x
net jog-y   axis.y.jog-enable   <=   pendant.jog-y
net jog-z   axis.z.jog-enable   <=   pendant.jog-z

# Set the scales per count / Faktor je count setzen
# we could set them to fix value like
# setp axis.z.jog-scale   0.05
# setp axis.y.jog-scale   0.05
# setp axis.x.jog-scale   0.05
# but also better do connect them to the jog- increments of gmoccapy. 
net scale axis.z.jog-scale   <=   axis.y.jog-scale   <=   axis.x.jog-scale   <=   gmoccapy.jog.jog-increment

# Connect all counts to Jogwheel-counts / Alle count san Jogwheel-counts anbinden
net override-counts       pendant.override-wheel-counts
net override-counts       gmoccapy.rapid.rapid-override.counts
net override-counts       gmoccapy.feed.feed-override.counts
net override-counts       gmoccapy.spindle.spindle-override.counts
net override-counts       gmoccapy.jog.jog-velocity.counts

# the scales of the counts are set on the settings page of the GUI, not here
# this is different from using halui pin!!

# jog velocity mode on (1) or off(0) / Geschwindigkeitsmodus an (1) oder aus (0)
# 0 is default / 0 ist Standardwert
# Mode 0 : after spinning the dial, axis may go on moving, because counts are still pending, Mode 1 will ignore pending steps
# Mode 0 : Nach dem drehen des Handrades kann die Achse noch weiterlaufen, da noch Schritte auszuführen sind. Mode 1 hält sofort an
setp axis.x.jog-vel-mode 1
setp axis.y.jog-vel-mode 1
setp axis.z.jog-vel-mode 1

net feed           gmoccapy.feed.feed-override.count-enable         <=   pendant.feed
net spindle        gmoccapy.spindle.spindle-override.count-enable   <=   pendant.spindle
net maxvel         gmoccapy.rapid.rapid-override.count-enable       <=   pendant.rapid
net jogvel         gmoccapy.jog.jog-velocity.count-enable           <=   pendant.jogvel 

net incr-0         gmoccapy.jog.jog-inc-0    <=    pendant.rbt_incr_0
net incr-1         gmoccapy.jog.jog-inc-1    <=    pendant.rbt_incr_1
net incr-2         gmoccapy.jog.jog-inc-2    <=    pendant.rbt_incr_2
net incr-3         gmoccapy.jog.jog-inc-3    <=    pendant.rbt_incr_3
net incr-4         gmoccapy.jog.jog-inc-4    <=    pendant.rbt_incr_4
net incr-5         gmoccapy.jog.jog-inc-5    <=    pendant.rbt_incr_5